Tektronix THS710A Manuale Utente Scaricare il pdf (Pagina 109)

Maintenance

THS710A, THS720A, THS730A & THS720P Service Manual

6–27

Insert circuit board tabs

into chassis holes

Route battery cable into

slot in chassis (not shown)

Figure 6–16: Reassembling the chassis

7. To install the display cable, follow these steps:

a. Use the

inch flat-bladed screwdriver to open the connector on the

main board.

b. With the conductive contacts facing away from the main board, insert the

display cable into its connector.

c. Use the

inch flat-bladed screwdriver to close the connector and then

check that the display cable is fully inserted into the connector.

d. Dress the display cable down through the slot in the chassis.

8. Turn the chassis assembly over so that the main board is facing down.

9. Install the display module and inverter board using steps 1 through 9 of the

procedure on page 6–18.

10. Install the chassis assembly into the back cover using steps 1 and 2 of the

procedure on page 6–20.

11. Install the switch mat and front cover using the procedure on page 6–12.

12. If detached, install the tilt stand using the procedure on page 6–9.

This completes the reassembly of the instrument.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 141 142

Nessun commento

Tektronix THS710A Manuale Utente Pagina 109